A spark plug blow out occurs when the spark plug is fastened too tightly or not tight enough to the engine plug. The result is that the spark plug itself cannot properly channel the electric charge from the plug to the engine block, and the spark plug breaks down.
Beside above, will a lawn mower start with a bad spark plug?
A dirty or fouled spark plug can cause your lawn mower to not start. It can also work itself loose, causing issues. If the spark plug appears to be seated correctly but the engine doesn't start, a new one may be in order.
You shouldn't drive with a blown spark plug and since you probably can't get it out because the heat has welded the spark plug, you need to remove the coil and the inductor wires from the blown spark plug so that way that particular spark plug is disabled and won't do damage to the engine.
Place the spark plug socket on the plug and try to turn it out by ¼ turn. If it still won't budge, try tightening it ¼ turn. The whole point of this exercise is to move the threads enough so the rust penetrant can wick into the threads. Once the plug turns, add more rust penetrating oil.
Spark plugs that haven't been changed for a long time can become one with the cylinder head. Fortunately, it's possible to repair damaged threads instead of scrapping the head. ... In fact, it may be possible to simply chase the old threads with a tap and clean them up. Or, as illustrated, you can insert a Helicoil.
Generally the plugs degrade over time, causing weak spark, poor combustion and reduced gas mileage. In most cases, a failure would cause a single cylinder to stop firing, causing strange engine sound and loss of power.
However, you can not spray the carburetor when the engine is off since it cannot do the cleaning without being propelled. All you need to do is to start the engine and spray directly at the center of the carburetor while it is running. Any deposits clogging in the carburetor will easily be removed.
Using WD-40 to repel water from spark plugs, distributors, alternators, and batteries is a good way to prevent corrosion and keep moisture away. You can also use it to ease the removal of spark plugs, especially if there is any rust or corrosion.Share to:FacebookTwitterPinterestEmail