How do you drain the oil on a Craftsman lawn mower?
In this regard, where the drain plug is located?
Secondly, where is the oil drain on a riding lawn mower?
Locate your oil drain plug on bottom of the motor on either the left or right side of the engine compartment. Some drains have a twist cap, others a valve you turn by hand, and still others require a wrench to turn the valve.
Is SAE 30 the same as 10W30?
Yes, you can make use 10W30 engine oil instead of the SAE30 in your Lawn Mower. ... Older engines can use the SAE30, while the 10W30 is for modern engines. Again, the SAE30 is better for warmer temperatures while the 10W30 is suitable for varying temperature ranges and also works well in cold weather.SAE 30- Warmer temperatures, most common oil for small engines. SAE 10W-30- Varying temperature range, this grade of oil improves cold-weather starting, but may increase oil consumption. Synthetic SAE 5W-30- Best protection at all temperatures as well as improved starting with less oil consumption.Look at the bottom of the engine oil pan. Around the bottom of the pan, you should see a single bolt. That's your oil drain plug. (Some vehicle models use a similar round plug, which you can pull to drain the oil.)The general range is between $100 and $350, but there are some vehicles that cost more. You can get an oil pan gasket replacement for between $40 and $150. The part is not the most expensive part of the repair, but the labor can be very intensive.The idea of performing maintenance, even a relatively simple task such as an oil change, may seem daunting, if not downright impossible. However, changing your own oil can be more convenient and less expensive than taking your vehicle to a local express lube shop.SAE 10W-30 4-Cycle Lawn Mower Oil (20 oz.) - CMXG0AW1320 | CRAFTSMAN.For best lawnmower engine performance, you should change oil after the first 5 hours of use for a new mower, then at least once every spring or summer mowing season or every 50 hours of operation, which ever comes first.The 19.5 hp lawn tractors take 48 U.S. fluid ounces, or 1.5 U.S. quarts, of detergent motor oil at each oil change. The oil must conform to API service classification SF, SG or SH. When operating at air temperatures above 32 degrees Fahrenheit, use SAE 30 motor oil.