How do I know which spark plug for my lawn mower?
Spark plugs are typically located on the back or side of a lawn mower engine. Look for a short wire that's about 1/4-in. -thick leading to the top of a short, cylindrical protrusion from the engine. If you're not sure where the spark plug is, consult your owner's manual.
Moreover, are lawn mower spark plugs universal?
Spark plugs aren't universal; you have to make sure that you buy one that fits your mower. ... If you no longer have the manual or the number has rubbed off, you can always remove the plug first and take it to AutoZone with you.
- You can't get the engine to fire up at all.
- You have to tug extra hard for longer than usual on the rewind.
- Your lawn mower loses power while moving.
- The gas runs out quicker than it used to.
One may also ask, what spark plug do I need for my Briggs and Stratton?
Flathead Engine Spark Plugs & Gaps
|Replacement Part Type||Briggs & Stratton Spark Plug Part Number||Spark Plug Gap|
|Extended Life Series® OHV Spark Plug Platinum (Replaces Champion RC12YC)||696202 5066 (5066D, 5066H)||.030”|
|Resistor Spark plug - hotter spark (Replaces Champion RC14YC)||496018S 5092||.030”|
Will any spark plug work in a lawn mower?
The spark plugs in both types of engine work on the same basic principle. ... Some automotive and lawn mower spark plugs may be interchangeable, but many others are not because of physical differences.For standard lawn mower and small engine maintenance, you should check and/or replace spark plugs:
- once a season.
- every 25 hours of use.
- if your lawn mower our outdoor power equipment won't start.
The engine misfires or runs rough. The engine starts, but stalls shortly after. There is a noticeable increase in fuel consumption during normal equipment use.However, you can not spray the carburetor when the engine is off since it cannot do the cleaning without being propelled. All you need to do is to start the engine and spray directly at the center of the carburetor while it is running. Any deposits clogging in the carburetor will easily be removed.Using WD-40 to repel water from spark plugs, distributors, alternators, and batteries is a good way to prevent corrosion and keep moisture away. You can also use it to ease the removal of spark plugs, especially if there is any rust or corrosion.